|
|
發表於 2012-7-8 17:48:09
|
顯示全部樓層
本帖最後由 正一 於 2012-7-8 06:01 PM 編輯
gkjnn大你好..感謝分享...請問改公板時 PIN1, PIN2 ,PIN21 要如何接或是不接線..謝謝
Pin No. Symbol Description Note
1 ODSEL Overdrive Lookup Table Selection (2)
2 RPF Display Rotation (3)
3 NC No connection (4)
4 GND Ground
5 RX0- Negative transmission data of pixel 0
6 RX0+ Positive transmission data of pixel 0
7 GND Ground
8 RX1- Negative transmission data of pixel 1
9 RX1+ Positive transmission data of pixel 1
10 GND Ground
11 RX2- Negative transmission data of pixel 2
12 RX2+ Positive transmission data of pixel 2
13 GND Ground
14 RXCLK- Negative of clock
15 RXCLK+ Positive of clock
16 GND Ground
17 RX3- Negative transmission data of pixel 3
18 RX3+ Positive transmission data of pixel 3
19 GND Ground
20 NC No connection (4)
21 SELLVDS Select LVDS data format (5)
22 NC No connection (4)
23 GND Ground
24 GND Ground
25 GND Ground
26 VCC Power supply: +5V
27 VCC Power supply: +5V
28 VCC Power supply: +5V
29 VCC Power supply: +5V
30 VCC Power supply: +5V
Note (1) Connector Part No.: FI-E30S(JAE) or compatible
Note (2) Overdrive lookup table selection. The Overdrive lookup table should be selected in accordance to the
frame rate to optimize image quality.
ODSEL Note
L or Open Lookup table was optimized for 60 Hz frame rate.
H Lookup table was optimized for 50 Hz frame rate.
Note (3) Low or open: normal display (default), High : display with 180 degree rotation
Note (4) Reserved for internal use. Left it open.
Note (5) Ground: JEIDA, High or OPEN: Normal LVDS format
Please refer to 5.5 LVDS INTERFACE (Page 17)
|
|
/1 
發表於 2011-8-7 21:14:12
樓主